;
; Configuration file name : !ACC1200.CFG       12/06/1991
; For EISA EtherNet Adapter

BOARD
   ID = "ACC1200"
   NAME = "AcerLan(e) 32-bit EISA-bus Ethernet Adapter"
   MFR = " "
   CATEGORY = "NET"
   SLOT = EISA
   LENGTH = 195
   READID = YES
   BUSMASTER = 23
   AMPERAGE = 1000
   IOCHECK = INVALID
   DISABLE = SUPPORTED
   COMMENTS = " The 32-bit EISA-bus Ethernet Adapter is a 32 bit EISA
		bus master adapter based on SONIC Ethernet controller."
   HELP = "32-bit EISA-bus Ethernet Adapter\n
	   This configuration file allows selection of the following:\n
	   1. BOOT ROM disable/enable\n
	   2. Bus master preempt time\n
	   3. Interrupt channel\n
	   4. Burst or non-burst transfer\n
	   5. Physical media selection"

IOPORT(1) = 0zc88h
   SIZE = WORD
   INITVAL = 0000xxx1010x0xxx
				;slave size=16, master size=32
				;interrupt unlatched
;IOPORT(2) = 0zc89h
;   INITVAL = 0000xxx1           ;Slot-Specific, receive own packets
IOPORT(2) = 0zc8Ah
IOPORT(3) = 0zc8Fh
   INITVAL = 00xxx0x0

FUNCTION = " Ethernet BOOT ROM start address"
      CHOICE = "BOOT ROM Disabled "
	FREE
	  INIT = IOPORT(2) LOC(7-6) 00

      CHOICE = "BOOT ROM 27128 (16K x 8)"
	FREE
	  INIT = IOPORT(2) LOC(7-6) 10
	LINK
	  MEMORY = 16K
	  ADDRESS = 0C0000H-0DC000H step=16K
	  WRITABLE = NO
	  MEMTYPE = OTHER
	  SIZE = BYTE
	  DECODE = 24
	  CACHE = YES
	  INIT = IOPORT(2) LOC(5-3) 000|001|010|011|100|101|110|111


FUNCTION = "Interrupt channel"
TYPE = "NET"

    CHOICE = "Edge Triggered Interrupt"
	LINK
	  IRQ = 3|5|7|9|10|11|12|15
	     TRIGGER = EDGE
	     SHARE = NO
	  INIT = IOPORT(1) LOC(10 2 1 0) 0011|0101|0111|0001|1001|1011|1101|1111

    CHOICE = "Level Triggered Interrupt"
	LINK
	  IRQ = 3|5|7|9|10|11|12|15
	     TRIGGER = LEVEL
	     SHARE = YES
	  INIT = IOPORT(1) LOC(10 2 1 0) 0010|0100|0110|0000|1000|1010|1100|1110


FUNCTION = "Physical Media"
      CHOICE = "Coaxial cable (Thin Ethernet)"
	FREE
	INIT = IOPORT(1) LOC(9) 1

      CHOICE = "UTP/AUI cable"
	FREE
	INIT = IOPORT(1) LOC(9) 0