BOARD
ID="CPQ0671"
NAME="Compaq ProSignia 200"
MFR="Compaq"
CATEGORY="SYS"
SLOT=EMB(0)
READID=YES
SIZING=0M
VERSION=1.2AH
REV=0

SYSTEM
NONVOLATILE=32768
AMPERAGE=20000
PCI_MEMORY=32M-544M
PCI_PORT=7000h-0FFFFh

SLOT(1)=PCI(0,13)            LABEL="Slot 1"
SLOT(2)=PCI(0,12)            LABEL="Slot 2"
SLOT(3)=PCI(0,11)            LABEL="Slot 3"
SLOT(4)=ISA16-PCI(4,0,10)    LABEL="Slot 4"
SLOT(5)=ISA16(5)             LABEL="Slot 5"
SLOT(6)=OTHER(6), "CPU"      LABEL="Proc"

;System Cache Map
MEMORY=640K  ADDRESS=0K    CACHE=YES STEP=1024K
MEMORY=256K  ADDRESS=640K  CACHE=NO
MEMORY=128K  ADDRESS=896K  CACHE=YES STEP=1024K
MEMORY=1023M ADDRESS=1024K CACHE=YES STEP=1024K
MEMORY=1024M ADDRESS=1024M CACHE=YES STEP=1024K

IGNORE=PCI(0,20)

SWITCH(1)=8
NAME="SWITCH"
STYPE=DIP
REVERSE=YES
VERTICAL=NO
;FACTORY=LOC(1-8)01011100
;INITVAL=LOC(1-8)01011100
COMMENTS="Ratio and System Maintenace Switch Positions:
\n
\nProcessor Speed       1       2       3       4
\n
\n  233MHz             OFF     ON      OFF     ON
\n  266MHz             OFF     ON      OFF     ON                
\n  300MHz             OFF     ON      OFF     ON 
\n  333MHz             OFF     ON      OFF     ON   
\n
\nProcessor Speed       5       6       7       8
\n
\n  233MHz             ON      ON      OFF     OFF
\n  266MHz             ON      OFF     ON      ON
\n  300MHz             ON      OFF     ON      OFF
\n  333MHz             ON      OFF     OFF     ON"     

SWITCH(2)=4
NAME="SW2"
STYPE=DIP
REVERSE=YES
VERTICAL=NO
FACTORY=LOC(1-4)1010
INITVAL=LOC(1-4)1010
COMMENTS="System Maintenance Switch Positions:
\n1 -  OFF=User Power-on password override disabled,
\n     ON =User Power-on password override enabled.
\n2 -  OFF=Retain System configuration,
\n     ON =Erase System configuration on boot.
\n3 -  OFF=Floppy boot control, dependent on configuration selection,
\n     ON =Floppy boot enabled (configuration selection override).
\n4 -  Reserved" 


INCLUDE="CPQSYS06.OVL"
BEGINOVL

;os
INCLUDE="CPQOS3.CMN"

;sid
FUNCTION="System Identification Number"
CHOICE="None"
CHOICE=""

;floppy
GROUP="Integrated Diskette Controller"
INCLUDE="CPQFPY2.CMN"
FUNCTION="" SHOW=NO CHOICE=""
ENDGROUP


;fdisk
GROUP="Integrated Fixed Disk Controller"

 FUNCTION="Primary Interface"
  RESOURCE="CNTRORD", UNIQUE
  TYPE="MSD,DSKCTL"
  
  HELP="The Integrated Fixed Disk Controller can be Enabled or
  Disabled.  If Enabled, the fixed disk drive in Unit 1 must 
  contain your operating system. Disabling the controller is a 
  method of allowing an external fixed disk controller to be used 
  at this address."
 
  CHOICE="Enabled as First Controller"
  SUBTYPE="CTL1;CMOS=260400+291010"
  LINK
  MEMBER="CNTRORD", "1"
  PORT=01F0h-01F7h
  PORT=03F4h-03F7h
   SHARE="MSD"
  IRQ=14
 
  CHOICE="Disabled"
  SUBTYPE="DIS1;CMOS=260404+291000"
  DISABLE=YES

  CHOICE="Enabled as Second Controller"
  SUBTYPE="CTL2;CMOS=260400+291010"
  DISABLE=YES
  LINK
  MEMBER="CNTRORD", "2"
  PORT=01F0h-01F7h
  PORT=03F4h-03F7h
   SHARE="MSD"
  IRQ=14

 
 FUNCTION="  Drive Type - Primary Unit 1"
 ; COMMENTS="\nCAUTION: The attached disk drive type was automatically
 ; determined.  This selection may be changed, but selecting the wrong
 ; drive type will cause improper operation of the fixed disk.\n\n"
 
  TYPE="MSD,UNIT0,DSKDRV"
  INCLUDE="CPQDKTYP.CMN"
  
 FUNCTION="  Drive Type - Primary Unit 2"
 ; COMMENTS="\nCAUTION: The attached disk drive type was automatically
 ; determined.  This selection may be changed, but selecting the wrong
 ; drive type will cause improper operation of the fixed disk.\n\n"
 
  TYPE="MSD,UNIT1,DSKDRV"
  INCLUDE="CPQDKTYP.CMN"
 
 
 FUNCTION="Secondary Interface"
   RESOURCE="CNTRORD", UNIQUE
  TYPE="MSD,DSKCTL"
  
  HELP="The Integrated Fixed Disk Controller can be Enabled or
  Disabled. Disabling the controller is a method of allowing 
  an external fixed disk controller to be used at this address."
 
  CHOICE="Enabled as Second Controller"
  SUBTYPE="CTL2;CMOS=260400+291010"
  LINK
  MEMBER="CNTRORD", "2"
  PORT=0170h-0177h
  PORT=0374h-0377h
   SHARE="MSD"
  IRQ=15
 
  CHOICE="Disabled"
  SUBTYPE="DIS2;CMOS=260404+291000"
; DISABLE=YES

  CHOICE="Enabled as Third Controller"
  SUBTYPE="CTL3;CMOS=260400+291010"
  LINK
  MEMBER="CNTRORD", "3"
  PORT=0170h-0177h
  PORT=0374h-0377h
   SHARE="MSD"
  IRQ=15
 
 
 FUNCTION="  Drive Type - Secondary Unit 1"
 ; COMMENTS="\nCAUTION: The attached disk drive type was automatically
 ; determined.  This selection may be changed, but selecting the wrong
 ; drive type will cause improper operation of the fixed disk.\n\n"
 ;
  TYPE="MSD,UNIT2,DSKDRV"
  INCLUDE="CPQDKTYP.CMN"

 FUNCTION="  Drive Type - Secondary Unit 2"
 ; COMMENTS="\nCAUTION: The attached disk drive type was automatically
 ; determined.  This selection may be changed, but selecting the wrong
 ; drive type will cause improper operation of the fixed disk.\n\n"

  TYPE="MSD,UNIT3,DSKDRV"
  INCLUDE="CPQDKTYP.CMN"

 INCLUDE="CPQSOFT.CMN"
 INCLUDE="CPQSOFT.CMN"
ENDGROUP


;memory
FUNCTION="System Rom" SHOW=NO
RESOURCE="CPQSCSIROM",UNIQUE
RESOURCE="CPQSCSI8XX",UNIQUE

CHOICE=""
FREE MEMBER="CPQSCSIROM","Y" SHARE=NO
FREE MEMBER="CPQSCSI8XX","Y" SHARE=NO
FREE MEMORY=128K ADDRESS=896K CACHE=YES MEMTYPE=OTH WRITABLE=NO

GROUP="Compaq Memory"
TYPE="MEM;Compaq"
FUNCTION="Base Memory"
RESOURCE="MEMORY",UNIQUE
CHOICE="640 Kbytes, Linear"
FREE
MEMORY=640K             ADDRESS=0K       CACHE=WRITEBACK

FUNCTION="Extended Memory (1-16MB)"
CHOICE="Memory Installed"
HELP="This function will map memory in the extended memory
range below 16 megabytes." 
SUBCHOICE
FREE
MEMBER="MEMORY","LINEAR"
MEMORY=14M | 15M ADDRESS=1M      CACHE=WRITEBACK

FUNCTION="Extended Memory (16-512MB)"
CHOICE="Memory Installed"
TOTALMEM=0M-496M STEP=1024K 
HELP="This function will map memory in the extended memory
range above 16 megabytes." 
SUBCHOICE
FREE
MEMBER="MEMORY","LINEAR"
MEMORY=0M-48M STEP=1024K ADDRESS=16M         CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=64M         CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=128M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=192M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=256M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=320M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=384M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=448M        CACHE=WRITEBACK



FUNCTION="Super Extended Memory (512-1024MB)"
CHOICE="Memory Installed"
TOTALMEM=0M-512M  STEP=1024K
HELP="This function will map memory in the super extended memory
range above 512 megabytes." 
SUBCHOICE
FREE         
MEMORY=0M-64M STEP=1024K ADDRESS=512M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=576M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=640M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=704M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=768M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=832M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=896M        CACHE=WRITEBACK
MEMORY=0M-64M STEP=1024K ADDRESS=960M        CACHE=WRITEBACK





FUNCTION="Total Memory"
CHOICE=""
ENDGROUP




;security
INCLUDE="CPQSEC4.CMN"

GROUP="Power-on Features"
FUNCTION="Diskette boot control"
HELP="This feature enables and disables system start-up
from the diskette drive.  Disabling diskette boot
prevents the drive from being used to start the computer.
The diskette drive, however, remains active for all
other transactions such as reading or writing to a diskette."
CHOICE="Enable Floppy Boot"
CHOICE="Disable Floppy Boot"

FUNCTION="Diskette write control"
HELP="This feature enables and disables writing to
the diskette drive.  Setting this feature to 'read
only' will not allow writes to the diskette drive.
Setting this feature to 'read and write' will allow
normal operation of the diskette drive."
CHOICE="Read and write"
FREE
INIT=PORTADR(000E9h) rrrrr1rr
CHOICE="Read only"
FREE
INIT=PORTADR(000E9h) rrrrr0rr

FUNCTION="ROM POST Speed Up"
HELP="This feature enables and disables the system start-up memory
count.  When enabled, the Power On Self Test procedure (POST) will skip
the memory test."
CHOICE="Enabled"
SUBTYPE="CMOS=2D1010"
CHOICE="Disabled"
SUBTYPE="CMOS=2D1000"

FUNCTION="Server Cover Removal Warning"
HELP="This feature enables and disables a ROM Power On Self Test (POST)
message which informs the user whether the system chassis cover has been
removed."
CHOICE="Enabled" 
SUBTYPE="OTH,PANEL"
CHOICE="Disabled"
ENDGROUP

;ec01
;integrated i/f
GROUP="Integrated Interfaces"
INCLUDE="CPQSER2S.CMN"
INCLUDE="CPQPAR2M.CMN"
INCLUDE="CPQPNTR2.CMN"
ENDGROUP

;CSM
INCLUDE="CPQCSM.CMN"



INCLUDE="CPQDSP2.CMN"

;adv features
INCLUDE="CPQFEATG.CMN"

;revision info
INCLUDE="CPQREV.CMN"

ENDOVL



IOPORT(110)=0C94h  INITVAL=000000xx
IOPORT(111)=0C9Ah  INITVAL=rrrxrrrr
IOPORT(112)=0C6Dh INITVAL=rrrxxxrr
FUNCTION="" SHOW=NO CHOICE=""
LINK
INIT=IOPORT(110)LOC(1 0)11
INIT=IOPORT(111)LOC(4)0
INIT=IOPORT(112)LOC(4-2)101

;ec09
;FUNCTION="EISA Reserved" SHOW=NO CHOICE=""
;LINK
;PORT=7C80h-7C83h
;PORT=8C80h-8C83h
;PORT=9C80h-9C83h
;PORT=0AC80h-0AC83h
;PORT=0BC80h-0BC83h
;PORT=0CC80h-0CC83h
;PORT=0DC80h-0DC83h
;PORT=0EC80h-0EC83h
;PORT=0FC80h-0FC83h

FUNCTION="Processor Control" SHOW=NO CHOICE=""
FREE
MEMORY=1K ADDRESS=80C00000h MEMTYPE=VIR SIZE=DWORD CACHE=NO
FREE
IRQ=13 SHARE="SYSIRQA"

GROUP="System Information"
TYPE="ISA" 
FUNCTION="Slot Mapping Information" SHOW=NO CHOICE="Slot Mapping Tables"
SUBTYPE="MAP"
FREEFORM=30,81h,82h,83h,24h,25h,86h,0E0h,0E0h,
0E0h,0E0h,0E0h,0E0h,0E0h,0E0h,0E0h,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0

FUNCTION="PCI Slot Mapping Information" SHOW=NO CHOICE="PCI Slot Mapping Tables"
SUBTYPE="PCIMAP"
FREEFORM=12,01h,00h,68h,02h,00h,60h,03h,00h,58h,04h,00h,50h
ENDGROUP