BOARD			;10/31 fcm Chg
 ID="ISA8508"
 NAME="DCA IRMA2 3279 Graphics Adapter"
 MFR="DCA"
 CATEGORY="COM"
 SLOT=ISA8
 LENGTH=336
 COMMENTS="
 This is actually an IRMA2 card connected to a Forte Graph piggyback card.\n\n
 This board is identified by a 4 position DIP Package on the back 
 of the IRMA2 board. There is also a version based on IRMA which has 
 a three Jumper Block labeled J1-J3 instead of the DIP SW."

SWITCH(1)=4
 NAME="S1"
 STYPE=DIP
 FACTORY=LOC(4-2) 111
 INITVAL=LOC(1) 0
 COMMENTS="
 The switch is located on the back of the board with the edge connector."

JUMPER(1)=2
 NAME="J1"
 JTYPE=INLINE
 REVERSE=YES
 FACTORY=LOC(1^2 2^3) 10
 COMMENTS="
 J1 is used to select the video adapter on the system. It is located on 
 the face of the graphics piggyback attachment (no card edge)."

SOFTWARE(1)="
 Set Configuration parameters in Software as Follows: "

FUNCTION="IRMA2 3279 Config Options"
 SUBFUNCTION="3279 Emulation"
 TYPE="COM,SYN"
 CHOICE="IRMA Compatibility (IO Port 220)"
 LINK
 PORT=280h-28Fh|2C0h-2CFh|2A0h-2AFh|300h-30Fh
 INIT=SWITCH(1) LOC(4-3) 11|10|01|00
 INIT=SOFTWARE(1) "\tIO=280"|"\tIO=2C0"|"\tIO=2A0"|"\tIO=300"
 LINK
 PORT=220h-227h
 INIT=SWITCH(1) LOC(2) 1
 INIT=SOFTWARE(1) "\tIO=220"
 CHOICE="No IRMA Compatibility"
 LINK
 PORT=280h-28Fh|2C0h-2CFh|2A0h-2AFh|300h-30Fh
 INIT=SWITCH(1) LOC(4-2) 110|100|010|000
 INIT=SOFTWARE(1) "\tIO=280"|"\tIO=2C0"|"\tIO=2A0"|"\tIO=300"
 SUBFUNCTION="Graphics Adapter Selection"
 CHOICE="EGA/VGA"
 FREE
 INIT=JUMPER(1) LOC(1^2 2^3) 10
 CHOICE="All Others"
 FREE
 INIT=JUMPER(1) LOC(1^2 2^3) 01