Article: Q79889
Product(s): Microsoft Windows 95.x Retail Product
Version(s): WINDOWS:3.0,3.0a,3.1,3.11
Operating System(s):
Keyword(s):
Last Modified: 13-DEC-1999
-------------------------------------------------------------------------------
The information in this article applies to:
- Microsoft Windows versions 3.0, 3.0a, 3.1, 3.11
-------------------------------------------------------------------------------
SUMMARY
=======
If you are using the Stacker XT/8 Coprocessor with Microsoft Windows running in
386 enhanced mode, you need to add an EMMExclude statement to the [386Enh]
section of the SYSTEM.INI file.
NOTE: This does not apply to the Stacker AT/16 Coprocessor because it does not
use a RAM address.
MORE INFORMATION
================
The range of memory addresses depends on the base address of the Stacker XT/8
card. The base address is found on the Stacker DEVICE statement in the
CONFIG.SYS file and is identified by the /B parameter.
The following table lists the seven possible memory ranges, based on the base
address of the XT/8 Coprocessor card:
Base Address <range> to Exclude
------------ ------------------
c400 c400-c7ff
c800 c800-cbff
cc00 cc00-cfff
d000 d000-d3ff
d400 d400-d7ff
d800 d800-dbff
dc00 dc00-dfff
For example, if the Stacker XT/8 Coprocessor base address is d000, using Notepad,
add the parameter listed below to the SYSTEM.INI file under the heading
[386Enh]:
EMMEXCLUDE=d000-d3ff
The Stacker products included here are manufactured by a vendor independent of
Microsoft; we make no warranty, implied or otherwise, regarding these products'
performance or reliability.
REFERENCES
==========
Stacker version 2.0 README.DOC
Additional query words: 3.0 3.0a 3.00 3.00a 1.1 3.1 3.10 2.0 coprocessor 3.11 co processor
======================================================================
Keywords :
Technology : kbWin3xSearch kbZNotKeyword3 kbWin300 kbWin300a kbWin310 kbWin311
Version : WINDOWS:3.0,3.0a,3.1,3.11
=============================================================================