Article: Q94896
Product(s): Microsoft Windows 3.x Retail Product
Version(s): WINDOWS:3.1,3.11
Operating System(s):
Keyword(s):
Last Modified: 10-OCT-1999
-------------------------------------------------------------------------------
The information in this article applies to:
- Microsoft Windows for Workgroups versions 3.1, 3.11
-------------------------------------------------------------------------------
SYMPTOMS
========
If an Intel EtherExpress 16 is installed on a machine and there is a hardware
conflict, such as an I/O Port address or an interrupt request line (IRQ) being
duplicated on two devices, the following error message may occur during
startup:
Failure: EtherExpress 16 Hardware Not Found, Driver not loaded.
Failure: NDIS environment invalid, Driver not loaded.
WORKAROUND
==========
Because the Intel EtherExpress 16 is a software-configured network card, the
only workaround to this error message is to put the card into another machine
and use the following steps to reconfigure it.
NOTE: This message may occur if the network card isn't seated properly in the
machine. Check to be sure that this isn't the problem before reconfiguring the
card as discussed below.
1. On the first machine, load Windows for Workgroups.
2. Run Control Panel.
3. In the Control Panel window, choose the Network icon.
4. Choose the Adapters option to remove the driver for the Intel EtherExpress 16
network card.
5. When prompted to Restart Computer or Continue, choose Continue, then exit
Windows and turn off the machine.
6. Remove the Intel card from the first machine, turn off a second machine which
doesn't have a hardware conflict, remove any network cards from the second
machine, and place the Intel card into the second machine.
7. Turn on the second machine and load Windows for Workgroups.
8. Run Control Panel.
9. In the Control Panel window, choose the Network icon, and choose the Adapters
option to remove any other network card drivers and install the driver for
the Intel EtherExpress 16.
10. Change either the I/O Port address or the IRQ to an unused value on the
first machine.
11. When prompted to Restart Computer or Continue, choose Restart Computer and
then let the machine restart. Once it has restarted, turn the second machine
off and remove the Intel card.
12. Place the card back into the first machine, turn it on, and load Windows for
Workgroups.
13. Run Control Panel.
14. In the Control Panel window, choose the Network icon and choose the Adapters
option to add the driver for the Intel EtherExpress 16. Use Setup to
configure it for the new settings, which were set up on the second machine.
15. When prompted to Restart Computer or Continue, choose Restart Computer and
then let the machine restart. The error message should no longer occur and
Windows for Workgroups should operate normally.
16. If the error message still occurs, there may still be a hardware conflict
and the above steps should be repeated until it is resolved.
The Intel EtherExpress 16 network interface card is set up exclusively with
software, either with Windows for Workgroups or Intel's Softset utility. If
there is a hardware conflict, the options changed by the Setup software are
never written to the card because the software can't communicate with it due to
the I/O Port address or IRQ conflict. Because there is no other way to adjust
the hardware settings on the Intel EtherExpress 16, it has to be configured in
another machine and then moved back to the original machine.
KBCategory: kbnetwork kb3rdparty kbhw
KBSubcategory: wfw wfwg
Additional query words: 3.10 3.11 Ether Express 3rdparty boot bootup software configured
======================================================================
Keywords :
Technology : kbAudDeveloper kbWFWSearch kbWFW310 kbWFW311
Version : WINDOWS:3.1,3.11
=============================================================================