Article: Q114370
Product(s): Microsoft Windows 3.x Retail Product
Version(s): WINDOWS:3.11
Operating System(s):
Keyword(s):
Last Modified: 22-SEP-1999
-------------------------------------------------------------------------------
The information in this article applies to:
- Microsoft Windows for Workgroups version 3.11
-------------------------------------------------------------------------------
SYMPTOMS
========
When you start Microsoft Windows for Workgroups version 3.11 with Novell
connectivity installed through IPXODI, the following error may occur:
The following error occurred while loading protocol number 0.
Error 58: The network has responded incorrectly. You may need to reconfigure
the protocol using Network Setup. If your computer is a portable, make sure
it is connected to its docking station."
NOTE: Choosing OK in this dialog box allows Windows to load; however, the
Microsoft Windows Network is disabled.
CAUSE
=====
When you install Novell IPXODI support in Windows for Workgroups 3.11, Setup
must make certain assumptions about the IPXODI configuration since Windows for
Workgroups 3.11 does not ship with any of the Novell ODI files. One of the
assumptions concerns the specific name of the multiple link interface driver
(the Novell ODI network interface card driver). This name is referenced in the
PROTOCOL.INI file on the Bindings= line(s). If the driver name specified on the
Bindings= line does not match the name of the multiple link interface driver
(MLID) being used, the above error may be generated.
RESOLUTION
==========
To correct this error, make a note of the actual name of the MLID file listed
after LSL.COM in the AUTOEXEC.BAT or STARTNET.BAT file. Edit the PROTOCOL.INI
file and verify that the Bindings= line matches the MLID file described above.
If the Bindings= entry does not match the MLID name, correct the line so that it
does.
NOTE: On some configurations there may be two Bindings= lines.
Example
-------
The following example uses a 3Com Etherlink III (3C5x9) NIC, which is one of the
more common cards with which the above error message occurs. Below are excerpts
of the files created by Network Setup.
AUTOEXEC.BAT:
C:\WINDOWS\NET START
C:\<PATH>\LSL.COM
C:\<PATH>\<3C5X9.COM> (This is the MLID.)
C:\<PATH>\IPXODI.COM
C:\WINDOWS\ODIHLP.EXE
C:\<PATH>\NETX.EXE
PROTOCOL.INI:
[NWLINK]
Bindings=3C509
[NETBEUI]
Bindings=3C509
Note that the MLID filename in the AUTOEXEC.BAT file is 3C5x9.COM, but the
PROTOCOL.INI file references 3C509; including the file extension will result in
the problem not being resolved. The corrected PROTOCOL.INI should read as
follows:
[NWLINK]
Bindings=3C5x9
[NETBEUI]
Bindings=3C5x9
For more information about this error in non-ODI configurations, query on the
following words in the Microsoft Knowledge Base:
netbeui and wfwg and ndis and tshoot
Additional query words: adapter 3.11 netware
======================================================================
Keywords :
Technology : kbAudDeveloper kbWFWSearch kbWFW311
Version : WINDOWS:3.11
=============================================================================