Article: Q130071
Product(s): Microsoft Windows 95.x Retail Product
Version(s):
Operating System(s):
Keyword(s):
Last Modified: 17-DEC-2000
-------------------------------------------------------------------------------
The information in this article applies to:
- Microsoft Windows 95
-------------------------------------------------------------------------------
SYMPTOMS
========
You receive the following error message when you are running Windows 95 Setup to
upgrade an existing Windows 95 installation:
Setup checked the hard disk(s) on your computer and found that there may be
problems. You need to check your disk(s) before continuing Setup.
To repair these problems, quit Setup and then run ScanDisk from Windows. Then
run Setup again.
When you run ScanDisk in Windows 95, no errors are reported.
CAUSE
=====
This error message can occur if there is a damaged DoubleSpace or DriveSpace
compressed volume file (CVF) that is not mounted. The ScanDisk test run by
Windows 95 Setup checks unmounted CVFs.
RESOLUTION
==========
To work around this behavior, use either of the following methods:
- Run ScanDisk on the unmounted CVF by typing the following line at a command
prompt
" scandisk <drive>:\<dblspace.nnn> " (without the quotation
marks)
where <drive> is the letter of the hard disk containing the CVF and
<dblspace.nnn> is the name of the CVF. Note that the CVF may be named
DRVSPACE.<nnn>.
- Rename the CVF file so that Setup will not check it and then run Setup again.
To rename the CVF file, type the following line at a command prompt
" ren <drive>:\<dblspace.nnn> dscvf.<nnn> " (without the
quotation marks)
where <drive> is the letter of the hard disk containing the CVF,
<dblspace.nnn> is the name of the CVF, and <nnn> is the extension
of the CVF. Note that the CVF may be named DRVSPACE.<nnn>.
NOTE: The unmounted CVF may have its Hidden, System, or Read-Only attributes
set. Before you rename the file you may have to remove these attributes. To
do so, type the following line at a command prompt
" attrib -s -h -r <drive>:\<dblspace.nnn> " (without the
quotation marks)
where <drive> is the letter of the hard disk containing the CVF and
<dblspace.nnn> is the name of the CVF. Note that the CVF may be named
DRVSPACE.<nnn>.
MORE INFORMATION
================
When you run Windows 95 Setup from MS-DOS or Windows 3.x, Setup does not check
unmounted CVFs. Setup checks unmounted CVFs only when you run Setup from an
existing Windows 95 installation.
Additional query words: scandskw
======================================================================
Keywords :
Technology : kbWin95search kbZNotKeyword3
=============================================================================