Article: Q149675
Product(s): Microsoft Exchange
Version(s): winnt:4.0,5.0,5.5
Operating System(s):
Keyword(s):
Last Modified: 22-MAR-1999
-------------------------------------------------------------------------------
The information in this article applies to:
- Microsoft Exchange Server, versions 4.0, 5.0, 5.5
-------------------------------------------------------------------------------
SUMMARY
=======
When you try to send mail out a PCMTA connector to a DOS Microsoft MHS gateway,
you might receive the following error:
Your message did not reach all or some of the intended recipients.
MORE INFORMATION
================
Check the following configuration in the Microsoft Exchange Administrator
program:
1. Verify that the Address Space on the PC Mail Connector has:
TYPE Address COST
MHS 1
If MHS is not a type, use New General to add it. Then Stop and Start the PC
Mail Connector service.
2. Verify that the Site, Configuration, Site Addressing Object, Routing Tab for
the MHS address is defined properly. If it is not, go back to step one and
remove and recreate the address space.
3. Recalculate Routing on the Site, Configuration, Site Addressing Object,
Routing tab.
4. On the MS Mail connector Properties Connections tab, verify that the Access
component is hanging off the gateway PO. If it is there, but is not shown
under the gateway MS Mail PO, remove the access component from the connector
PO and reinstall it, so that it is pointing to the MS Mail gateway PO.
Additional query words:
======================================================================
Keywords :
Technology : kbExchangeSearch kbExchange500 kbExchange550 kbExchange400 kbZNotKeyword2
Version : winnt:4.0,5.0,5.5
=============================================================================