Cybrary: Evo D500 Ultra-Slim Desktop - Configuring System Board

Evo D500 Ultra-Slim Desktop

System Board


System Board Components

The system board features a micro ATX form factor with the following components:
Top of Page

System Board Removal/Replacement

 
System Board Removal

Before you begin: Remove the access panel, front bezel, hard drive, MultiBay assembly, system memory, heatsink, processor, and legacy module (if it is installed).

  1. Disconnect all cables from the system board, noting their location for reinstallation.
  2. Remove the retaining screws from the system board.
  3. Slide the board about one-half inch toward the back of the chassis so it clears the three pegs on the chassis base pan, then lift it up and out of the chassis.
System Board Replacement
  1. Slide the board into the chassis so that the connectors align with the I/O panel ports.
  2. Lower the board over the three pegs in the chassis base pan.
  3. Slide the board forward to lock the pegs into the sockets on the board.
  4. Replace the retaining screws. 
  5. Reconnect all cables to the system board. 
Top of Page


This page was updated on June 02, 2002
Comments about this page
Privacy and Legal Statement