|
ZIDA |
|
MANUAIS DE MOTHERBOARDS ZIDA |
Jumper
Settings for 6MLX
CPU Speed Selection
| CPU Speed (MHz) | External Bus Speed (MHz) | JP2 | JP3 | JP4 | JP5 | Frequency Ratio |
| 233 | 66 | Open | Open | Close | Close | 3.5x |
| 266 | 66 | Close | Close | Open | Close | 4x |
| 300 | 66 | Open | Close | Open | Close | 4.5x |
| 333 | 66 | Close | Open | Open | Close | 5x |
CPU
Voltage Selection
The CPU voltage is automatically detected. No jumper
setting is needed.
CMOS Reset
If you want to reset the CMOS data, please follow the procedures as
below:
1. Switch off the power supply of your system
2. Set jumper JP11 to position 2-3
3. Then reinstall the jumper to position 1-2
| Jumper | JP11 |
| Normal | 1-2 |
| Reset | 2-3 |
After CMOS reset, all data
in CMOS will be lost. So you need to re-enter the data again.
Other Jumpers
JP16 and JP17 are for Flash BIOS type select. The default settings are
1-2.
| Jumper | Default setting |
| JP16, JP17 | 1-2 |