For instructions and limitations on creating the diskette, click here:
Warning:
(1) Power should be supplied by the AC adapter with a charged battery installed!
(2) Do not hit CTRL+ALT+DELETE, ALT+C, or CTRL+BREAK during download of the firmware!
(3) At the start of downloading the firmware, the progress indicator displays "0%" for about 10 seconds. This is normal.
Installation Guide
The hard disk drive firmware update must be applied from the bootable update diskette, as described below. The update utility cannot be run from the hard disk drive.
1. Shutdown the operating system and power off the ThinkPad.
2. Insert the Firmware Update Diskette.
3. Power on the ThinkPad. It will boot to the Utility Software screen.
4. After the drive is listed on the screen, type "y" and press the Enter key to select the drive.
5. After the firmware is prepared (as indicated on the screen), type "y" and press the Enter key. Then the firmware update will begin.
- After the update is complete, remove the diskette and turn off the ThinkPad. Wait 5 seconds before turning the ThinkPad on again.
Note: If no applicable hard disk drive is found in the ThinkPad, or if the update has already been applied to the hard disk drive in the ThinkPad, the following message will be displayed:
"1) port 0 master 'HDD model' is not supported by this tool."
where 'HDD model' is the model of the HDD detected by the utility.
|