|
4.150 bytes |
Parts Information |
Document ID: DDSE-433LBP |
Netfinity 5000 - External Options
Applicable to: World-Wide
External Options
The information in this section supplements the instructions that come with the external options (SCSI drives, printers, modems, and other serial and parallel devices). To connect external options, see the documentation that comes with the options.
Adding External SCSI Devices: Your server comes with a 16-bit UltraSCSI controller on the system board, which provides two independent SCSI channels. This controller has two 68-pin, shielded, high-density connectors: one internal, on the controller, and one external, on the back of the server. You can use these connectors to install an additional internal SCSI device in your server or to attach up to fifteen external SCSI devices to your server.
The internal SCSI connector provides support for SCSI devices installed inside the server. The external SCSI connector provides support for external SCSI devices.
|
Notes
If you plan to install both internal and external SCSI devices, you must follow the instructions given in Internal Drives Installation or Removing in addition to the instructions in this section. Read Internal Drives Installation or Removing, and then return here.
For additional information about SCSI configurations supported, see
http://www.pc.ibm.com/netfinity/
Do not exceed the following cable lengths:
- If you connect one or more Fast SCSI devices to the SCSI controller, the total length of all cables (internal and external) must not exceed 3 meters (9.8 feet).
- If you do not connect Fast SCSI devices to the SCSI controller, the total length of all cables must not exceed 6 meters (19.7 feet). |
You must set a unique SCSI ID for each external SCSI device so that the controller can identify the devices. The controller can then ensure that different devices do not attempt to transfer data at the same time. Therefore, do not set the SCSI IDs for external devices to the values you used for the controller.
If you plan to attach an external SCSI device, you might need to order an additional SCSI cable. To use an external device with the Netfinity 5000, you must connect it to the external SCSI connector, using a SCSI cable. This SCSI cable must have the proper connector for the SCSI external connector on one end, and the proper connector for the external device on the other end. If a SCSI cable does not come with the external device, or if it is the wrong type, you will need to order one.
Attaching External Options: To attach an external option:
1. Turn off the server and all attached devices.
2. Follow the instructions that come with the option and the illustration in Input/Output Connectors to connect it to the server.
|
|
Search Keywords |
|
|
Document Category |
CD-ROM Drives, Hard Drives, Printers, Tape Drives, Communications |
|
|
Date Created |
11-12-98 |
|
|
Last Updated |
02-02-99 |
|
|
Revision Date |
02-02-2000 |
|
Brand |
IBM PC Server |
|
Product Family |
Netfinity 5000 |
|
|
Machine Type |
8659 |
|
|
Model |
ALL |
|
|
TypeModel |
|
|
|
Retain Tip (if applicable) |
|
|
|
Reverse Doclinks
and Admin Purposes |
|