|
2.061 bytes |
Service Hints & Tips |
Document ID: DETR-3TQG8N |
|
This document is provided to IBM and our Business Partners to help sell and/or service IBM products. It is not to be distributed beyond that audience or used for any other purpose. |
Aptiva - Installing OS/2 Warp
Applicable to: World-Wide
Service Information: Not Commercial Desktop
There are several things that need to be checked before installing Warp on an Aptiva and these are as follows:-
1. In the CMOS settings make sure that the following are true:-
a. Rapid Resume is disabled.
b. Read Prefetch is disabled (this is not on some Aptiva's).
c. APM BIOS mode is set at 16-bit.
Note:
To enter the CMOS settings simply force a keyboard error by pressing a key down as soon as the machine is switched on and keeping the key down until the machine starts to 'beep' frantically.
2. Finally your hard drive should not be compressed unless this has been done by Stacker v4.0 for DOS and OS/2.
|
Search Keywords |
| |
|
Hint Category |
OS/2, Software Installation/Configuration | |
|
Date Created |
15-08-95 | |
|
Last Updated |
10-12-98 | |
|
Revision Date |
10-12-99 | |
|
Brand |
IBM Aptiva | |
|
Product Family |
Aptiva, OS/2 Warp | |
|
Machine Type |
2144, 2168 | |
|
Model |
| |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |