2.897 bytes |
Service Hints & Tips |
Document ID: PFAN-3UDL74 |
TP 770/E/ED - CPU Removal and Installation Information
Applicable to: World-Wide
Follow the HMM CPU removal information. Use a small flat blade screw driver in the designated slot to loosen the CPU card.
Do NOT pull the CPU card from its socket before loosening it.
The CPU card pins must all seat simultaneously during installation. To do this place the card over the socket. Then position your fingers at the two corners and on the white silk screened spot at the center of card over the connector. Press down with even pressure until the connector clicks into the socket.
Figure 1.
The Zeros and the white silk screened dot indicates where to press during installation.
__________________
________
------
<--HEAT SINK
------
Lifting latch------>(-
X = white dot 0 X 0<----Zeros
________________
IBM Mobile Systems Hardware Maintenance Manual Volume 4 form number S05L-1270.
IBM HMM Internet URL: http://www.pc.ibm.com/us/cdt/hmm.html
Search Keywords |
| |
Hint Category |
Hardware Maintenance Information | |
Date Created |
11-05-98 | |
Last Updated |
17-08-98 | |
Revision Date |
14-08-99 | |
Brand |
IBM ThinkPad | |
Product Family |
ThinkPad 770, ThinkPad 770E/ED | |
Machine Type |
9548, 9549 | |
Model |
Various | |
TypeModel |
| |
Retain Tip (if applicable) |
| |
Reverse Doclinks |