|
4.823 bytes |
Service Hints & Tips |
Document ID: VLAR-3DSSG2 |
Multimedia Modem Plus - Manually configuring for Windows (US Only)
Applicable to: United States
Note: If you are upgrading from the Multimedia Modem or have any other Mwave software installed in your computer, you must remove the old Mwave software to avoid conflicts with the new Mwave software. The setup program that is part of your installation package should be used to remove the old Multimedia Modem Mwave software from your hard disk drive.
Normally you should use the Automatic Setup and Test option to configure your Multimedia Modem Plus. However, if a conflict is found or you are using the CD-ROM controller interface, you must manually change the appropriate configuration settings.
NOTE: Use this procedure to change settings other than the CD-ROM parameters only if you are familiar with the setup of your operating system.
Depending on the complexity of your system, the configuration program might not accurately detect all system parameters.
To manually change the settings:
1. At the DOS prompt, Type CONFIG and press ENTER.
2. Select OK to enter the CONFIG.EXE program.
3. Press TAB to go to Setup, and then press ENTER.
Use the TAB keys to move the cursor. Your mouse does not work while the CONFIG.EXE program is running. Tab to the setting that you want to change. When the setting is highlighted, press the ENTER key and choose the desired value using the up and down arrow keys. When finished, press ENTER.
The CD-ROM TYPE and BASE I/O ADDRESS must be set manually.
4. Select OK, and then press ENTER.
5. Select TEST and then press ENTER to start the configuration tests. If the tests do not complete successfully, change the settings and re-test.
6. When the configuration is complete and all test have successfully completed:
Record the configuration information. You will need it if you plan to install Multimedia Modem Plus under OS/2 Warp and Windows in the same computer.
a. Select EXIT, and press ENTER to end the configuration program and save your configured settings.
b. Answer yes to the questions about updating your system files when you are prompted by the program.
c. Shutdown and restart Windows or Windows 95.
|
Search Keywords |
| |
|
Hint Category |
DOS/Windows 3.x, Modems, Multimedia | |
|
Date Created |
29-01-97 | |
|
Last Updated |
25-01-99 | |
|
Revision Date |
19-11-99 | |
|
Brand |
IBM Options | |
|
Product Family |
Modems, Multimedia | |
|
Machine Type |
28.8K, Audio | |
|
Model |
42H4320 | |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |