|
2.347 bytes |
Service Hints & Tips |
Document ID: DETR-3TAQHX |
Aptiva - Operating Requirements
Applicable to: World-Wide
Operating Requirements:
All machines have two power-on switches: one on the system unit and one on the display (if the display was shipped with the model). Some high voltage machines (180 - 259V ac) might have a power cord from the display to the system unit and a non-switched appliance connector.
High voltage Northern and Southern Hemisphere SVGA displays might come with a voltage selector switch, allowing selection of voltage of either 110V ac or 220V ac. This switch must be in the 220 V ac position when the machine is plugged into a 220V ac electrical outlet.
When the system unit is powered off for 10 seconds or more and then powered on, the power supply generates a ¿power good— signal that resets the system logic.
Note:
Whether or not Rapid Resume is enabled, the on/off switch on the system unit does not completely power off the power supply. Also, the appliance outlet connector is always powered on when the system unit is plugged into an electrical outlet. See ¿Rapid Resume— for more information.
A Note About Energy Saver Monitors:
- Monitors rated as ¿Energy Saver— models use less than 30 W when operating in the energy-saving mode or when the system unit is powered off.
- To extend monitor life, the monitor should be powered off at the end of each day.
|
Search Keywords |
| |
|
Hint Category |
Power Management, Power | |
|
Date Created |
24-09-96 | |
|
Last Updated |
17-12-98 | |
|
Revision Date |
17-12-99 | |
|
Brand |
IBM Aptiva | |
|
Product Family |
Aptiva | |
|
Machine Type |
2144, 2168 | |
|
Model |
| |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |