;Protocol.ini for the ACCTON EtherCoax/Pair-NE(2)
;Ethernet cards
;
;PROTOCOL.INI PARAMETERS
;
; This is a sample PROTOCOL.INI file for the ACCTON EtherCoax/Pair-NE(2) NDIS
; MAC driver. The [ETHNE] section shows examples of ETHNE configuration
; parameter settings.  Comments at the end of the file explain these parameters
; and give their default, minimum and maximum values.  The [protocol manager]
; and [netbeui] sections aren't meant to be complete or realistic examples,
; except for the "BINDINGS = ETHNE" line in the [netbeui] section.
;	The only parameter that must be specified is the "drivername".  Note
; that many of these parameters have default values (which are given below
; under "Comments about ETHNE parameters"). A parameter need not be specified
; in your PROTOCOL.INI if its default value is satisfactory.
;
;drivername
;     units:[n/a]
;     range:[ethne$]
;     default:[ethne$]
;
;     This parameter's value must be ETHNE$, it identifies the network
;     device driver.
;
;The following entries are optional under the [ETHNE] section.
;
;irq
;     units:[integer]
;     range:[2-7,10,12]
;     default:[3]
;
;     On an 80286 or 80386 computer, specifying interrupt level 2
;     will be redirected to interrupt level 9 because the cascaded programmable
;     interrupt control (PIC) is already using interrupt level 2.
;     Not all values are supported by all adapters.
;
;iobase
;     units:[hex]
;     range:[300-360]
;     default:[300]
;
;     Indicates the base I/O address for the network adapter card.
;     This entry must match the adapter card's I/O address jumper settings.
;
;maxmulticast
;     units:[integer]
;     range:[1-1000]
;     default:[10]
;
;     Specifiese the maximum number of multicast address.
;
;maxrequests
;     units:[integer]
;     range:[8-32]
;     default:[8]
;
;     Specifies the number of request queue entries.
;
;maxtransmits
;     units:[integer]
;     range:[8-50]
;     default:[12]
;
;     Specifies the number of transmit queue entries.
;
;receivechains
;     units:[n/a]
;     range:[6-96]
;     default:[12]
;
;     Specifies the number of receive chain header queue entries.
;
;receivebuffers
;     units:[integer]
;     range:[6-96]
;     default:[12]
;
;     Specifies the number of receive buffer queue entries.
;
;receivebufsize
;     units:[bytes]
;     range:[256-1536]
;     default:[256]
;
;     Specifies the size, in bytes, of a receive buffer.
;
