      --------- The MDM and RAM files on my BBS ----------

           *****************************************
           *  BBS Type:  WildCat 3.9               *
           *  Modem:  Smart One 1442FX (external)  *
           *  Other Comm Programs Used:  MLink     *
           *****************************************


      The SmartOne modem by Best Data has two Banks of memory 
  settings as well as an active bank.  BBS-1.RAM loads the BBS's
  settings into Bank 1 of the modem.  MLink-0.RAM loads my comm
  programs (MLink for Windows) into Bank 0.  The other file, 
  "SMARTBBS.MDM" sets up your makewild with proper modem settings
  for the SmartOne modem as well as telling it that the proper 
  init string are in Bank 1 of the modem.

      The only difficulty I have is that MLink cannot configure
  init strings well and I have to manually type "ATZ" at the 
  beginning of running it to change the active Bank to match 
  Bank 0.  You may not have this problem.

      If you use other comm programs, then conf them into Bank 0
  by writing them to the active Bank and typing "AT&W" or write
  your own RAM file with WCMODEM.

      Make sure you use "ATZ" and not "ATZ1" with your comm 
  programs as I find that the "BBS-1.RAM" file works great with
  WildCat, but does NOT work well with comm programs.  The 
  problem seems to be with the &T5, V1, and W2 commands (change
  to &T4, V0, and W0 in the case of my comm program).

      I make no promises that these files will work for you.  
  They seem to work fine on my system.  If you wish to talk to
  me about improving them or just some help, contact me at my 
  BBS or thru the echo addresses below.

                          Jama Lucas, Sysop
                          Health & Education BBS
                          (705) 424 5505
                          
                          RIME RelatNet, "HEALTHED", 5388
                          NANet, 70-51-09
