                    ----------------------------------------
Here is the proper setup to use with Wildcat 3.50 (released 6/15/92) to
allow bidirectional file transfers. This same batch file also works
with Wildcat's Tomcat QWK mail door to allow bidirectional mail
transfers. The batch file will work for both Desqview systems (which I
run -- 5 nodes) and non-DV systems, and with any comm port address or
IRQ since it picks up that information from the environment variables
that Wildcat uses. Alternately, -PB and -PI can be replaced with simply
-P%2 if using standard comm addresses and IRQs.

The same batch file can be used for both the Wildcat upload and
download batch files, as specified in wildcat, or you can use seperate
batch files if you prefer:

SH.BAT, placed in the Wildcat home directory.

@echo off
HSLINK -PB%WCBASEID% -PI%WCIRQID% -E%4 -I2 -HS -NV %5
       |<----- or -P%2 -------->|              | |
                          Remove if not DV---> |-|

The Wildcat 3.50 Makewild setup:


 06-21-92               External Protocol Definition              


           Ltr      Name           Up .BAT        Down .BAT     Batch
                             
            H   HSLink           SH.BAT          SH.BAT           Y

---------------------------------------------------------------------

You MUST also have the following line in your environment for EACH
node so that the DSZ.LOG file winds up in the right place:

SET DSZLOG=drive\path\nodeworkdirectory\DSZ.LOG

For example: SET DSZLOG=C:\WC30\WCWORK\NODE1\DSZ.LOG

--------------------------------------------------------------------

        Regards,
        Tom Tcimpidis
        Sysop, The MOG-UR'S EMS
        818-366-1238/8929/6442
