01
0100
0030
Adjust
0040
Diagnose the problemo
0050
MIG Weld
0060
Repair
0070
Replace
0090
Cut muffler off welded system & replace
Replace converter back exhaust system
0110
Replace extension pipe
0120
Re-install
0130
Check antifreeze for protection level
0150
Press
0170
Remove & replace
0180
Remove & install
0190
NOTE:
0200
Pressure test cooling system /check for leaks.
0160
Refill & bleed cooling system.
0300
0010
Adjust rear brakes.
0020
Bleed hydralic brake system - (includes fluid)
Clean & adjust rear drum brakes.
Install new front disc brake pads.
Install new rear disc brake pads.
Remove & install pressed hub assemblies.
Remove & replace both front disc calipers.
Remove & replace both rear disc calipers.
Remove & replace both rear wheel cylinders.
0140
Remove & replace rear drum brake shoes.
Replace rear axle brake lines to cylinders.
Rebuild both rear wheel cylinders.
Lube & adjust emergency brake system.
0400
Remove & replace both front strut assemblies.
Remove & Replace both rear strut assemblies.
R & I both front struts - replace cartridges.
Change transmission fluid / filter / gasket.
R & I flywheel for resurfacing.
Remove & replace transmission with rebuilt
0500
R & R all listed tune-up parts & set timing.
Scope analysis of ignition system.
Replace plugs/set timing/adjust idle & check
Fine tune & adjust engine after installation.
0080
Remove carburetor - rebuild with new float.
Replace ignition cable set.
Remove spark plugs/sandblast clean & reinstall
Set ignition timing.
Replace distributor cap/rotor & ignition wires
Test charging system & load test battery.
Test fuel injection/pump system.
Diagnostic check of engine system.
Replace distributor cap & rotor.
Diagnose no-start condition.