1/12/93
The files SDEFRAG2.EXE and UNSTACK2.EXE in this archive are 
intended for use by registered Stacker 3.0 users only. 

To update your Stacker 3.0 files, copy SDEFRAG2.EXE and 
UNSTACK2.EXE to the directory where Stacker 3.0 is installed. 
This is typically C:\STACKER. If you are unsure of the location 
of your Stacker 3.0 files, examine your CONFIG.SYS and look 
for the line that begins
        
        DEVICE=C:\STACKER\STACKER.COM

where C:\STACKER is the drive and directory that Stacker 3.0 
is installed in.
You may also wish to update your Stacker 3.0 distribution disks 
so that any reinstallation of Stacker will install the updated 
files. To do this, copy the SDEFRAG2.EXE and UNSTACK2.EXE files 
to Disk 2 of the 3.5" disk and/or Disk 2 of the 5.25" high 
density disk.
If you are using the 5.25" low density disks, copy SDEFRAG2.EXE 
to Disk 2 and UNSTACK2.EXE to Disk 3.
