                          3Com Corporation
                NDIS 2.01 Drivers Installation Notes


 3Com's EtherLink/PCMCIA adapter cannot be directly installed into
 3+Open environments.  To utilize these adapters in a 3+Open environment,
 you must use 3Com's NETSETUP program and select one of the other listed
 3Com adapters, then modify the CONFIG.SYS and PROTOCOL.INI files and
 copy the appropriate EtherLink/PCMCIA driver to the workstation or
 server's boot device.  3Com recommends you select the 3C523 adapter from
 NETSETUP's list of adapters and make the following modifications.

 NOTE:  This example is for a default 3+OPEN DOS ENHANCED WORKSTATION.  
 The exact files copied and directory paths may vary depending on your
 particular installation.

 1. Modify the CONFIG.SYS file:

	a. Change the line:

	DEVICE=C:\3OPEN\DOSWKSTA\LANMAN\DRIVERS\ELNKMC.DOS

    to

	DEVICE=C:\3OPEN\DOSWKSTA\LANMAN\DRIVERS\ELPC3.DOS

 2. Use the DOS change directory command (CHDIR or CD) to move to the
    drivers subdirectory:

	CD C:\3OPEN\DOSWKSTA\LANMAN\DRIVERS

 3. Copy the EtherLink/PCMCIA NDIS driver (ELPC3.DOS) from the EtherDisk
    diskette's \NDIS\DOS subdirectory to this directory:

    COPY A:\NDIS\DOS\ELPC3.DOS C:

 4. Modify your PROTOCOL.INI file.  

    a. In the ADAPTERS section add the following:

    [ELINKPC3]
      DRIVERNAME = ELPC3$

    b. In the PROTOCOLS section, change all:

       BINDINGS = ETHERLINK/MC

       to

       BINDINGS = ELINKPC3


                        (%VER NDIS - 3+ Open v1.0b)

