Microsoft Product Support Services   All Products  |   Support  |   Search  |   microsoft.com Home  
microsoft.com
  Support Home  |   Self Support  |   Assisted Support  |   Custom Support  |   Worldwide Support  |

Detailed Description of INTERLNK Parallel Cable Pinouts


The information in this article applies to:
  • Microsoft MS-DOS operating system versions 6.0, 6.2, 6.21, 6.22


SUMMARY

The following signal descriptions are for the parallel cable pins required to use Interlnk.


Pin 2:                Data Bit 0          Active when High

Pin 3:                Data Bit 1          Active when High

Pin 4:                Data Bit 2          Active when High

Pin 5:                Data Bit 3          Active when High

Pin 6:                Data Bit 4          Active when High

Pin 10:               Acknowledge         Active when Low

Pin 11:               Busy                Active when High

Pin 12:               Out Of Paper        Active when High

Pin 13:               Select              Active when High

Pin 15:               Error               Active when Low

Pin 25:               Ground 


MORE INFORMATION

Descriptions of parallel and serial cables required to run Interlnk can be found in MS-DOS Help. For more information, type help interlnk-- notes at the MS-DOS command prompt and then press ENTER.

Additional query words: 6.00 6.20 inter link interlink

Keywords :
Version : MS-DOS:6.0,6.2,6.21,6.22
Platform : MS-DOS
Issue type :
Technology :


Last Reviewed: November 16, 1999
© 2000 Microsoft Corporation. All rights reserved. Terms of Use.


Article ID: Q121246

Last Reviewed:
November 16, 1999

Send to a friend

Provided by
Microsoft Product Support Services


Did the information in this article help answer your question?

Yes
No
Did not apply

Please provide additional comments about this information.
(255 character max)