|
8.311 bytes |
Service Hints & Tips |
Document ID: MNOK-42RQC8 |
Aptiva - 2176 Removals and replacements index
Applicable to: World-Wide
Removals and ReplacementsùMachine Type 2176
Note: The Machine Type 2176 might contain drives and devices not illustrated in this book. Follow replacement instructions for the same size device if in doubt. See Appendix B, ôModel/Monitor Configurations and FRU Part Numbersö on page B-1 for exact model configurations.
The arrows in the removals and replacements procedures show the direction of movement to remove a field-replaceable unit (FRU), to turn a screw, or to press a tab to release the FRU.
Begin all removals by removing the cover (and rear cover, if applicable).
When other FRUs must be removed prior to removing the failing FRU, they are listed at the top of the page. Go to the removal procedure for each FRU listed, remove the FRU, and then continue with the removal of the failing FRU.
To replace a FRU, reverse the removal procedure and follow any notes that pertain to replacement. See ôParts/Test Point Locationsö on page 5-1 for internal cable connection and arrangement information.
Before disconnecting any cables, note their locations. Reinstall any new FRUs with cables in the same locations.
Safety Notice 1:
Before removing any FRU, power-off the computer, unplug all power cords from electrical outlets, then disconnect any interconnecting cables.
Attention: The system board, processors, adapter cards, SIMMs, and upgrade processors can be damaged by electrostatic discharge. Use an electrostatic discharge (ESD) strap to establish personal grounding. If you donÆt have an ESD strap, establish personal grounding by touching a ground point with one hand before touching the static-sensitive FRUs.
Caution:
Before removing any FRU, power off the system unit, unplug all power cords from electrical outlets, disconnect any interconnecting cables, and disconnect any telephone cords.
The power supply might contain+ 5 V dc auxiliary power when the system is powered off. Be sure to unplug the power cord before attempting any replacements.
Warning:
The system board, processors, adapter cards, SIMMs, video memory modules, and upgrade processors can be damaged by electrostatic discharge. Use an electrostatic discharge (ESD) strap to establish personal grounding. If you don't have an ESD strap, establish personal grounding by touching a ground point with one hand before touching the static-sensitive FRUs.
The following documents are excerpts from the Hardware Maintenance Manual. They may contain references to tables, figures or pages from this original document.
|
Type 1 system board |
Type 2 system board | |
|
Handling ESD sensitive parts |
| |
|
Cover |
| |
|
3.5 Inch drive bays |
| |
|
5.25 Inch drive bays |
| |
|
Hard disk drives |
| |
|
Adapter cards |
| |
|
Power supply |
| |
|
Riser card |
| |
|
Memory (SIMM) |
| |
|
Memory (DIMM) |
N/A |
|
|
Cache memory |
|
|
|
Processor removal |
|
|
|
Lithium battery |
|
|
|
Indicator LED and cable |
| |
|
System Board |
|
|
Search Keywords |
| |
|
Hint Category |
Hardware Installation/Configuration | |
|
Date Created |
01-12-98 | |
|
Last Updated |
14-12-98 | |
|
Revision Date |
14-12-99 | |
|
Brand |
IBM Aptiva | |
|
Product Family |
Aptiva | |
|
Machine Type |
2176 | |
|
Model |
All | |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |
