|
4.517 bytes |
Service Hints & Tips |
Document ID: DETR-44BL7L |
Aptiva - 2162 Removals and replacements - Index
Applicable to: World-Wide
Note: The Machine Type 2162 might contain drives and devices not illustrated in these documents. Follow replacement instructions for the same size device if in doubt. See Appendix B, "Model/Monitor Configurations and FRU Part Numbers" on page B-1 of the HMM for exact model configurations.
The arrows in the removals and replacements procedures show the direction of movement to remove a field-replaceable unit (FRU), to turn a screw, or to press a tab to release the FRU.
Begin all removals by removing the cover (and rear cover, if applicable).
When other FRUs must be removed prior to removing the failing FRU, they are listed at the top of the page. Go to the removal procedure for each FRU listed, remove the FRU, and then continue with the removal of the failing FRU.
To replace a FRU, reverse the removal procedure and follow any notes that pertain to replacement. See "Parts/Test Point Locations" on page 5-1 of the HMM for internal cable connection and arrangement information.
Before disconnecting any cables, note their locations. Reinstall any new FRUs with cables in the same locations.
See Safety Notice 1: Translation on page xi of the HMM
Before removing any FRU, power-off the computer, unplug all power cords from electrical outlets, then disconnect any interconnecting cables.
Attention: The system board, processors, adapter cards, DIMMs, video memory modules, and upgrade processors can be damaged by electrostatic discharge. Use an electrostatic discharge (ESD) strap to establish personal grounding. If you donĘt have an ESD strap, establish personal grounding by touching a ground point with one hand before touching the static-sensitive FRUs.
- Cover
- Adapter card removal
- System board removal
- Lithium battery removal
- Processor removal
- Floppy drive removal
- Cache memory installation and removal
- Hard disk removal
- Memory (DIMM) installation and removal
- Media console cover removal
- Power supply removal
- Riser card removal
|
Search Keywords |
| |
|
Hint Category |
Hardware Installation/Configuration | |
|
Date Created |
20-01-99 | |
|
Last Updated |
11-03-99 | |
|
Revision Date |
11-03-2000 | |
|
Brand |
IBM Aptiva | |
|
Product Family |
Aptiva | |
|
Machine Type |
2162 | |
|
Model |
all | |
|
TypeModel |
| |
|
Retain Tip (if applicable) |
| |
|
Reverse Doclinks |